Support Grips
-
Payment
-
Origin
China Mainland
-
Minimum Order
1
-
Packing
Pieces
- Contact Now Start Order
- Description
Product Detail
Support Grips are used to hold the weight of electrical cable as it hangs in a vertical, sloping or horizontal position.
Electrical cable must be supported, or its dead weight can cause excessive strain or pullout at the connections resulting in power failure. Support grips also absorb additional strain from flexure, vibration, expansion and contraction. Support cable socks are made of galvanized steel Stainless steel, other material are available on request.
Select the Correct Support cable sock :
Step 1 Determine the grip style best suited for your application.
Step 2 Determine your cable outside diameter.
Step 3 Find the grip size that encompasses your cable diameter.
Step 4 Whenever possible, use a closed mesh that assembles over the cable end. If the cable end is not available, use a split mesh.
Step 5 Where available, select an eye style that suits your needs.
Step 6 Select the proper material.
Step 7 Estimate the tension to be put on the grip, establish the working load you require and compare this to the listed approximate breaking strength of the grip to insure that the grip will be strong enough.
Selectable lift eye: single eye / double eye , offset eye
Selectable weave: single weave / double weave / triple weave.
Selectable material: stainless steel / galvanized
Selectable duty : light duty / junior duty / heavy duty
Selectable Install Way : lace up / pre-laced / rod closing
You might also interested in :
Pulling Grips | Strain Relief Grips | Fiber Optic Grips |
- Strain Relief Grips 1 Pieces / (Min. Order)
- Offset Eye Support Cable Grips 5 Pieces / (Min. Order)
- Strain Relief Grips 1 Pieces / (Min. Order)
- Pulling Grips 1 Pieces / (Min. Order)
- Grid Parabolic Antenna, 20dB, 824-896MHz 15 Pieces / (Min. Order)
- 2.4GHz 12DBI Fiberglass Omni Direct Antenna 15 Pieces / (Min. Order)
- 698-2700MHz 5DBI Outdoor Broadband Omni Antenna 15 Pieces / (Min. Order)
- 1710-1880/1920-2170/2400-2500MHz Three Band Combiner, DCS/3G /WLAN Combiner 15 Pieces / (Min. Order)
- 700-2700MHz Low Power Splitter/Divider 15 Pieces / (Min. Order)
- 25W 30W RF Coaxial Attenuator 15 Pieces / (Min. Order)
- 10W RF Coaxial Attenuator 15 Pieces / (Min. Order)
- 5W RF Fixed Attenuator 15 Pieces / (Min. Order)
- 200 Watts Dummy Loads 15 Pieces / (Min. Order)
- 100 Watts Dummy Loads 15 Pieces / (Min. Order)
- 50 Watts RF Terminator 15 Pieces / (Min. Order)
- Single Hole Barrel Cushions 15 Pieces / (Min. Order)
- Three-run Standoff Kit Trapbox For Snap-in Hanger 15 Pieces / (Min. Order)
- Cluster Support Bracket 15 Pieces / (Min. Order)
- 38 Stand-off Adapters With Hardware Kit 15 Pieces / (Min. Order)
- Clip-In Coax Cable Hanger 15 Pieces / (Min. Order)